There are two different sets of brake caliper torque specs for your 2001 Dodge Ram 2500. These torque specs are for the 2002 and 2003 models. The 2002 model has larger brake calipers than the 2001 Dodge Ram 2500. You should use the appropriate torque for your brakes.
2001 Dodge Ram 2500 brake caliper torque
If you are considering repairing or replacing your brake system, you should refer to your vehicle’s assembly manual for brake caliper torque specs. In general, you should apply a torque of 250 lb-ft to the front brake calipers. However, before you do so, make sure to use the proper torque tool.
You can use a torque wrench to tighten the bolts that hold the brake caliper bracket. These bolts are typically M14, with a 10.9 head. The recommended torque is 100 ft-lbs. The manual does not mention the torque of the caliper mounting bracket bolts, so make sure to consult your owner’s manual for this information.
The rear brake caliper bracket must be installed before the brake pads are installed. It’s possible to need a c-clamp to compress the caliper pistons. When installing new brake pads, you should also tighten the tire rod to 40 ft-lbs. Once this is done, you can connect the brake caliper to the brake pads.
2002 Dodge Ram 2500 brake caliper torque
You’re going to need to know your brake caliper torque specs if you want to replace them on your 2002 Dodge Ram 2500. These specifications cover the bolts that hold the brake calipers to the brackets. The bolts on your brake calipers are a type M14 with a 10.9 on the head, and the torque for this bolt is 100 ft/lbs.
The torque specs for the bolts that hold the caliper bracket are listed in the assembly manual. These specs also cover the bolts that attach the brake caliper carrier to the steering knuckle. The torque for the bolts and studs is based on the manufacturer’s recommendations.
The caliper torque specifications on a 2001 Dodge Ram 2500 will differ depending on the brake package you select. The light-duty brake package uses dual piston calipers in the front and a single piston caliper in the rear. Both brake packages are designed to provide maximum stopping power and braking performance.
After removing the old caliper, install the new one on the rotor. Then, use the caliper spreader tool to push the piston back on the caliper. Be careful not to damage the protective rubber boot of the caliper. Once installed, apply grease to the clips and pads, but do not apply it to the rotor/pad friction surfaces. Make sure the caliper is pre-loaded to 130 ft-lb of torque before tightening it.